GE WM7M Instalační příručka stáhnout pdf (Strana 1)

GEH-5809

Wallmount

™

175 Luminaire

INSTRUCTIONS

READ THOROUGHLY BEFORE INSTALLING

MOST DWELLINGS BUILT BEFORE 1985 HAVE

SUPPLY WIRE RATED 60C. CONSULT A QUALIFIED

ELECTRICIAN BEFORE INSTALLING.

GENERAL

This luminaire is designed for outdoor lighting service,

and should not be used in areas of limited ventilation, or in

high ambient temperature enclosures. Best results will be

obtained if installed and maintained according to the

following recommendations.

UNPACKING

This luminaire has been properly packed so that no parts

should have been damaged during transit. Inspect to

confirm.

INSTALLATION

octagon or 2x4 rectangular). The unit may be attached to

the outlet box (not provided) with two 10-24 screws approxi-

mately 3/4'’ long (not provided). An alternate method of

mounting the unit over a surface-mounted outlet box is to

position the unit over the box and mount on the vertical

surface as above with two or four ‘’ bolts (not provided)

through the rear of the fixture. A gasket is provided with the

unit to be placed on the back of the housing between the

luminaire and the mounting surface. If additional sealing is

desired, caulk the back of the housing with generic non-

hardening sealer (not provided) across the top and down

both sides. For access to the mounting knockouts and wiring

compartment, remove the reflector by gently pushing down-

ward on the top of the reflector allowing the lip of the reflec-

tor to clear the notch in the housing. Rotate the reflector

forward and remove. After installation and wiring is com-

plete, replace the reflector by fully inserting the bottom edge

of the reflector into the two slotted tabs in the housing. Rotate

the reflector back into the housing and gently push down-

ward on the top of the reflector to allow the top edge to

engage the notch in the housing.

WIRING

Make all electrical connections in accordance with

the National Electrical Code and any applicable

local code requirements.

Verify that supply voltage is correct by comparing it

to nameplate.

If unit is designated as multivolt or multiwatt,

follow specific instruction.

Do not remove insulated connectors from wires not

needed for required voltage connection.

Route incoming supply conductors through clips

provided and maintain half inch minimum spacing

from ballast and reflector.

The refractor door is made with slide-off hinges, and

should be removed during installation and wiring to prevent

possible damage and permit better access. Customer wiring

enters through the center hole in the rear or through the ‘’

conduit hole located on the top. An easy access wiring

compartment behind the reflector is provided for electrical

connection. Knockout holes are provided to permit mounting

on vertical surfaces with two or four ‘’ bolts (not provided)

through the rear of the fixture. You can also attach the

luminaire to a suitable surface-mounted outlet box (3'’ or 4'’

WARNING

Risk of electric shock

• Turn power off before servicing

– see instructions

WARNING

Risk of fire

• Use supply wire specified on

nameplate

CAUTION

Unit will fall if not installed properly

• Follow installation instructions

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or

maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred

to GE Lighting Solutions.

Lighting Solutions

1 2 3 4

Shrnutí obsahu

Strany 1 - 175 Luminaire

GEH-5809Wallmount ™ 175 LuminaireINSTRUCTIONSREAD THOROUGHLY BEFORE INSTALLINGMOST DWELLINGS BUILT BEFORE 1985 HAVESUPPLY WIRE RATED 60C. CONSULT A QU

Strany 2 - CHECKING OUT THE SYSTEM

IF SINGLE VOLTAGE:All single voltage ballasts are pre-wired such thatuser need only connect the supply conductors.IF MULTIVOLT: (120/208/240/277 volts

Strany 3 - Luminaire Wallmount

GEH-5809Luminaire Wallmount ™ 175INSTRUCTIONSÀ LIRE AVEC SOIN AVANT D'INSTALLERAUX USA : LA PLUPART DES HABITATIONS BÂTIES AVANT1985 ONT UN CÂBL

Strany 4 - ATTENTION

35-201578-1E (10/00)2MONO-TENSION :Tous les ballasts sont précâblés et l'utilisateur n'a qu'à relierles fils d'alimentation pour l