GE LED Roadway Scalable Project Grade Cobrahead Instalační příručka Strana 2

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 16
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 1
MOUNTING
3
Installation to Mounting Arm for Luminaire with
4 Slip fitter Bolts and One Bottom Door:
Remove Power door by loosening captive screw,
releasing the door latch and opening door to a
vertical position.
Disconnect plug which connects top housing wiring
with ballast and plug which connects to LED optical
assembly.
Now grasp door securely in both hands and open
door further until it comes free from hinges in top
housing.
This occurs at approximately 35 degrees from vertical
on pole side of hinge. In this position hinge pins will
easily slide upward out of their hinge cradles in top
housing.
If necessary, adjust 4 pipe clamp bolts such that
opening is slightly larger than mounting pipe diameter.
The luminaire may be adjusted up or down with
respect to pipe.
A pad is provided on top of housing for convenient
application of hand level.
To mount, insert pipe into back of the luminaire until it
hits the leveling steps or stop that sticks down from
the top of housing.
Hold luminaire approximately level and snug up bolts
(4-5 foot-pounds).
INSTALLATION
4
This luminaire has been properly packed so that no
parts should have been damaged during transit.
Inspect to confirm.
UNPACKING
1
WARNING
Risk of injury. Do not rely on door latch to hold power
module door during installation/maintenance. The door latch
is provided only to aid in the fastening of the captive screw.
Luminaire must be mounted on 2-inch (50.8mm)
diameter mounting arm.
HANDLING
2
Damage may occur if luminaire is improperly handled
outside of pack.
Do not impact or stack luminaire after removal from
packaging.
CAUTION
Risk of injury.
The luminarie should be mounted so that
prolonged staring into the luminaire at a distance closer than
0.50m is not expected.
Installation to Mounting Arm:
Zobrazit stránku 1
1 2 3 4 5 6 7 ... 15 16

Komentáře k této Příručce

Žádné komentáře