GE GFPS & GFPT Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro ne GE GFPS & GFPT. GE GFPS & GFPT Installation Guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 2
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
GEH-3902H
INSTRUCTIONS
PF-400
®
Powerflood
®
Floodlight,
Glarefighter
Powerflood
®
and Turnpike
Luminaire
READ THOROUGHLY BEFORE INSTALLING
GENERAL
This luminaire is designed for outdoor lighting applications,
and should not be used in areas of limited ventilation, or in high
ambient temperature enclosures. Best results will be obtained if
installed and maintained according to the following recommen-
dations.
UNPACKING
This luminaire has been properly packed so that no parts
should have been damaged during transit. Inspect to confirm.
MOUNTING
CAUTION
Unit will fall if not installed properly
Follow installation instructions
WARNING
Risk of electric shock
Turn power off before servicing
see instructions
This floodlight is provided with either trunnion mounting,
pipe mounting, or wall mounting.
NOTE: The unit may be mounted to point from straight up to
straight down but in no case may the ballast be located
above the optical. To mount from overhead structures, use
the top trunnion option.
NOTE: For aimed-up application, remove two screws from
rear bottom corners of back housing and reinstall them in
front housing rear bottom corners.
1. TRUNNION MOUNTED UNITS — Mounted directly on a flat
surface. Mounting adapters are available for installation on
poles, cross-arms, pipes, etc.
The trunnion bracket has a clearance hole for a 3/4-inch bolt
used for attachment to such mountings. The 3/8-inch holes on
either side permit additional anchoring, where required.
Tighten side trunnion bolts to 50 -55 foot pounds.
2. A. NORMAL PIPE MOUNTED UNITS (2G) — The slipfitter
can be mounted on 1-7/8-inch O.D. through
2-3/8-inch O.D. or 2-7/8-inch O.D. through 3-inch
O.D. pipes. Three set screws are used to clamp the
floodlight securely to the pipe. Tighten set screws to
18 -22 foot pounds.
Figure 1
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or
maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred
to GE Lighting Solutions.
g
GE
Lighting Solutions
Zobrazit stránku 0
1 2

Shrnutí obsahu

Strany 1 - Lighting Solutions

GEH-3902HINSTRUCTIONSPF-400® Powerflood® Floodlight,Glarefighter™ Powerflood®and Turnpike™ LuminaireREAD THOROUGHLY BEFORE INSTALLINGGENERALThis lumin

Strany 2 - MAINTENANCE

CAUTIONRisk of burn• Allow lamp/fixture to cool beforehandlingWARNINGRisk of burn• Do not touch operating luminaireTARGETFRONT OF SIGHTREAR OF SIGHTFi

Komentáře k této Příručce

Žádné komentáře