GE EP Series Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro ne GE EP Series. GE EP Series Installation Guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 6
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
GE
Lighting Solutions
imagination at work
Lumination
TM
LED Luminaires
(Series EP14 + Lutron TVI-LMF-2A Eco)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
Installation Guide
WARNING/AVERTISSEMENT
RISK OF ELECTRIC SHOCK
• Turn power off before inspection, installation or removal.
• Properly ground electrical enclosure.
RISK OF FIRE
• Follow all NEC and local codes.
• Use only UL or IEC approved wire for input/output connections.
Minimum size 18 AWG (0.75mm
2
).
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant d’inspecter, installer ou de retirer l’unité.
• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation
électrique.
RISQUES D’INCENDIE
• Respectez tous les codes NEC et codes locaux.
• N’utilisez que des ls approuvés par UL pour les entrées/sorties de connexion.
Taille minimum 18 AWG (0.75mm
2
).
Prepare Electrical Wiring
Electrical Requirements
• The LED driver must be supplied with 120-277 VAC, 50/60 Hz and connected to an individual properly
grounded branch circuit, protected by a 15 or 20 ampere circuit breaker. Use Min. 75°C supply conductor.
Grounding Instructions
• The grounding and bonding of the overall system shall be done in accordance with National Electric Code
(NEC) Article 600 and local codes.
Zobrazit stránku 0
1 2 3 4 5 6

Shrnutí obsahu

Strany 1 - LED Luminaires

GELighting Solutionsimagination at workLuminationTM LED Luminaires(Series EP14 + Lutron TVI-LMF-2A Eco) BEFORE YOU BEGINRead these instructions comple

Strany 2 - Electrical Connections

Wiring DiagramElectrical ConnectionsLutron Interface0-10VOutputGNDNSwitched Hot/OutConstant Hot/InEcoSystemDigital LinkPSUFIXTURELineNeutralDALIDALI/0

Strany 3 - E1 and E2

5 6Connect AC line to black, white and green wires from Lutron interface with twist-on wire caps. Connect EcoSystem bus wires to the two purple Lutron

Strany 4 - Unit Installation

Unit InstallationTo adjust height and to level a xture, squeeze the tip of the gripper and pull the suspension cable to the desired height. Clip the

Strany 5

243On the 1st luminaire, disconnect the right-side suspension wire and “Y” shape suspension wire. Then on the 2nd luminaire, disassemble the left-side

Strany 6 - Specications

IND049-121712GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com1 - 8 8 8 - 6 9 - 4 3 - 5 3 3GE Lighting Solutions, LLC is a subsi

Komentáře k této Příručce

Žádné komentáře