GE ALC3 Instalační příručka stáhnout pdf

Lighting

Installation Guide

imagination at work

Linear Lighting

(ALC3 Series)

Albeo

LED Luminaire

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all NEC and local codes.

• Use only UL or IEC approved wire for input/output connections.

Minimum size 18 AWG.

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.

• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.

RISQUES D’INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N’utilisez que des ls approuvés par UL ou IEC pour les entrées/sorties de

connexion. Taille minimum 18 AWG.

Prepare Electrical Wiring

Electrical Requirements

• The LED driver must be supplied with 120-277 VAC, 50/60

Hz per product label and connected to an individual properly

grounded branch circuit, protected by a 15 or 20 ampere

circuit breaker.

Grounding Instructions

• The grounding and bonding of the overall system shall be

done in accordance with National Electric Code (NEC) Article

600 and local codes.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

Save These Instructions

Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (A)/NMB-3(A)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the

interference at his own expense.

Tools and Components Required

• ALC3 Series xture

• Chain or cable (80 lbs. minimum load rated)

or RodMount kit

Cord Install:

• SJO or SJOW cable

• UL Listed strain relief(s)

(Hubbell SEC5O strain relief or

UL listed equivalent)

Conduit Install:

• 1/2” trade size exible conduit

• 1/2” trade size conduit

1 2 3

Shrnutí obsahu

Strany 1 - LED Luminaire

GELightingInstallation Guideimagination at workLinear Lighting(ALC3 Series)AlbeoTM LED Luminaire WARNING/AVERTISSEMENTRISK OF ELECTRIC SHOCK• Turn pow

Strany 2 - Electrical Connections

315 6742Carefully unpack unit and properly inspect for defects before installing. Wear work gloves to prevent dirt and oil from being transferred to t

Strany 3 - Mounting Options

1 2Rod Mount KitOPTION BAttach all rod mount brackets to xture end plates using screws and lock washers supplied in the Rod Mount Kit.Secure 3/8” thr