GE 45130 Uživatelský manuál stáhnout pdf (Strana 9)

Learn button on the Control Center. The unit will

beep once.

Step 2 -

While holding the Learn button, press and

hold the Zone button to be erased. After ﬁve

seconds the Control Center will sound two beeps

and the Zone LED indicator will ﬂash twice.

Step 3 - Release all buttons. The Zone has

been erased.

Note: The Zone/Garage Door Sensor cannot be erased if:

- The Zone has been triggered for an Alert or alarm. The

Sensor/Zone must be reset.

- There is loss of signal from the Sensor to the Control

Center (such as low battery, or Sensor is out of range).

- The system is armed.

The Control Center will sound three beeps to indicate it could

not erase the Zone.

Testing a Sensor or your system

Once all the Sensors have been assigned to Zones

in the Control Center you can now test your system.

Ensure the Control Center can receive the signal

from the intended location of the Sensor before

permanently mounting a Sensor.

Step 1 - To place Control Center in Test mode

unplug AC adapter and remove batteries.

Step 2 - Press and hold the ‘Mute’ button and plug

the AC adapter back into the Control Center. When

all the LED indicators turn on, release the Mute

button. The Control Center is now in Test Mode and

any Sensor can now be tested in any Zone.

Step 3 - Set the Notiﬁcation Mode to switch ‘Alert’

position

and begin activating Sensors one at a time.

1 2 3 4

Arm

Zone

Armed Power

1 2 3 4

Alert

Chime

Off

Mute

Learn

Input DC 12V

Add a Sensor

Step 1

Press and hold

the Learn button

for three seconds

Step 3

Release the

Zone button

Step 4

Activate the Garage

Door Sensor

Step 2

Select the Zone number

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Komentáře k této Příručce

Žádné komentáře

GE 45130 Uživatelský manuál Strana 9

Komentáře k této Příručce

Související produkty a manuály pro Součásti zabezpečovacího zařízení GE 45130