GE 45603 Uživatelský manuál Strana 1

GE SmartHome™Wireless Lighting ControlFluorescent &Appliance Module45603Z-Wave® Certified Wireless Lighting Control

Load Sensing Load sensing is disabled when shipped from the factory. This feature can be enabled if desired. Setting parameter 29 to a value of 1 wi

devices using the lighting control classification. The 45601 deluxe remote with LCD readout can control other Z-Wave certified devices like thermostats

FCCU2Z45602-3The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph:The equipment has been teste

Important Note: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the ant

is a registered trademark of General Electric Company and is used under license to Jasco Products Company LLC, 10 E Memorial Rd., Oklahoma

Introduction:Thank you for your purchase of a GE Z-Wave® control device. Z-Wave technology is designed to automate lighting/home control and provide

The device plugged into the Z-Wave controlled outlet on this module must not exceed 600 watts (Incandescent); 1800W (15A) Resistive or ½ HP Motor. To

RISK OF FIRERISK OF ELECTRICAL SHOCKRISK OF BURNSWARNINGThe Load-Sense feature on this Z-Wave product will turn the power to the connected device ON w

Wireless RangeThis device complies with the Z-Wave standard of open-air, line of sight transmission distances of 65 feet. Actual performance in a hom

Effects of Home Construction on Wireless Range Between Z-Wave Enabled Devices.Note: The distances shown in the table below are typical examples. Actu

Please Note: Z-Wave home control networks are designed to work properly alongside 802.11 wireless computer networks, Bluetooth and other 2.4GHz or 5.

Basic OperationThe connected light can be turned ON in three ways: With a Z-Wave remoteManually with the push button on the Z-Wave moduleBy the Load-S

control network with your primary controller.- Refer to the instructions for your primary controller to access the network setup function and includ