Ge 49-80388 12-05 JR Uživatelský manuál stáhnout pdf (Strana 22)

OPTIONAL INSTALLATION:

REAR WALL VENTING

5″ round duct may be used on SHORT DUCT

runs of 3 feet or less, such as direct to outside

wall venting.

To convert blower exhaust direction, remove

four nuts behind the filter which hold blower

and wire finger guard.

Rotate blower and reinstall to vent chamber,

as shown above. Retighten nuts, but do not

overtighten.

INSTALLING THE DUCTWORK

Use galvanized or aluminum duct in 6″ round

or 3

⁄4″ x 10″ size, or a combination of both.

PVC duct should be used if installing under a

poured concrete slab.

NOTE: Local building code must be followed

in specifying approved type and schedule of

ALL duct used.

Always use an appropriate roof or wall cap

with damper. Laundry-type wall caps should

NEVER be used.

Install ductwork, making male-female

connections in the direction of airflow as

shown. Secure all joints with sheet metal

screws and duct tape to assure an airtight

seal.

Use the shortest and straightest duct run

possible. For satisfactory performance the

duct run should not exceed 100 feet

equivalent length. Refer to TABLE 1 of

equivalent lengths. Use TABLE 1 to calculate

the total equivalent length of the ductwork.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 71 72

Žádné komentáře

Ge 49-80388 12-05 JR Uživatelský manuál Strana 22